EE-331-E ELECTRONICS CIRCUIT SIMULATION LAB

CLASS WORK : 25
EXAM : 25

LIST OF EXPERIMENTS:

1. Simulate and study half-wave, full-wave, and bridge-rectifier using PSPICE windows

2. Simulate and study diode clipper and clamper circuits using PSPICE windows

3. Simulate and study emitter bias and fixed bias BJT and JFET circuits using PSPICE windows, and determine quiescent conditions.

4. Simulate a common emitter amplifier using self biasing and study the effect of variation in emitter resistor on voltage gain , input and output impedance using PSPICE windows .

5. Determine the frequency response of Vo/Vs for CE BJT amplifier using PSPICE windows. Study the effect of cascading of two stages on band width.

6. Simulate and study Darlington pair amplifier circuit using PSPICE windows and determine dc bias and output ac voltage .

7. Study an operational amplifier using PSPICE windows and find out: CMMR, gain band width product, slew rate, 3-db frequency, and input offset voltage.

8. Simulate and study active low pass, high pass, and band pass filters using PSPICE windows.

9. Simulate and study class A, B, C, and AB amplifier using PSPICE windows.

10. Study the operation of 555 timer oscillator using PSPICE.

11. Simulate logic expression………………..and determine its truth table.

12. Simulate logic expression of full adder circuit and determine its truth table.

13. Simulate a synchronous 4-bit counter and determine its count sequence.

14. Simulate a master-slave flip-flop using NAND gates and study its operation. Study the operation of asynchronous preset and clear .

NOTE : At least ten experiments have to be performed in the semester; out of which at least seven experiments should be performed from above list. Remaining three experiments may either be performed from the above list or designed & set by the concerned institution.

Related posts:

1. EE-325-E ANALOG ELECTRONIC CIRCUITS LAB
2. EE-222-E ANALOG ELECTRONICS-LAB
3. UPTU Syllabus | EEC -509 : ANALOG INTEGRATED ELECTRONICS LAB

EE-325-E ANALOG ELECTRONIC CIRCUITS LAB

CLASS WORK : 25
EXAM : 25

LIST OF EXPERIMENTS:

1. Design & measure the frequency response of an RC coupled amplifier using discrete components.

2. Design a two stage RC coupled amplifier and determine the effect of cascading on gain and bandwidth

3. Study the effect of voltage series, current series, voltage shunt, and current shunt feed-back on amplifier using discrete components.

4. Design & realize inverting amplifier, non-inverting and buffer amplifier using 741 Op Amp.

5. Verify the operation of a differentiator circuit using 741 op amp and show that it acts as a high pass filter.

6. Verify the operation of a integrator circuit using 741 op amp and show that it acts as a low pass filter.

7. Design and verify the operations of op amp adder and subtractor circuits.

8. Plot frequency response of AC coupled amplifier using op amp 741 and study the effect of negative feedback on

the bandwidth and gain of the amplifier.

9. Design & realize using op amp 741, Wein -bridge oscillator.

10. To design & realize using op amp 741, square wave generator.

11.To design & realize using op amp 741, logarithmic amplifier & VCCS.

NOTE: At least ten experiments are to be performed. Seven experiments should be performed from the above

list and the remaining three experiments can be either from the above list or set by the concerned institution as per the scope of the syllabus of EE-305-C.

Related posts:

1. EE-305-E-ANALOG ELECTRONIC CIRCUITS
2. EE-222-E ANALOG ELECTRONICS-LAB
3. EE-224-E DIGITAL ELECTRONICS LAB